Skip to main content

Water lines, Grainy Washes, Excess Water


Hard Waterlines 
Reapplying water to an area before it is completely dry can dilute color and carry the pigment to the outside edges, where it will accumulate, leaving unwanted hard lines. The obvious solution is to allow areas to dry completely before reapplying water or color. If you do form a waterline, try to soften it with a scrub brush or reapply water and glaze over it.

Grainy Washes
Mineral pigments and sedimentary colors tend to create grainy washes. Leaving your palette uncovered allows dust particles to accumulate, which may result in unwanted texture. Using a hair dryer to dry the damp pigment can flatten the sediment in the wash.

Warping and Buckling Paper
Watercolor tends to pool on lighter weight papers, often causing warping and buckling. Keep tilting your paper and moving the color to prevent pooling. A hair dryer will speed up the drying process. Hold it approximately 10 inches (25cm) away from the paper and keep the airflow moving evenly, or you can end up with areas that have dried too quickly, leaving unwanted lines.

Excess Water
To help control the drying time, remove excess water with a clean natural-hair brush. These are more absorbent than synthetic brushes. You can also use the tip of a paper towel, but don't press too hard or you may lift color, leaving an uneven dry area.

Backwashes and Blooming
Two areas drying at different rates can create back- washes and blossoming. During the drying process, water from the wetter, slower drying area seeps into the drier area, resulting in a blossom. Sometimes these are "happy accidents," but they can also be a disaster. 
If you have a very wet painting, try to keep an eye on it until it is almost dry--you never know what you will come back to. If a blossom has started to form, reapply water and pigment while it is still damp to even out the area. Remove the excess water and let dry. 
Worth Noting:
• Hard waterlines appear when an area is over wet and the pigment travels out to the edges. (above, left)
• Absorb water with a brush tip. A natural-hair brush acts like a sponge and will lift excess water out of an area. Natural hair is more absorbent than synthetic fibers. (above, middle)
• Absorb water with paper towel. The edge of a paper towel easily lifts out excess water. (above, right)

Comments

  1. Thank you for sharing this interesting and informative article, painting with airless spray gun will be faster and more interesting!

    Airless Spray

    ReplyDelete
    Replies
    1. Possibly but using an air gun or air spray gun, is not to be considered watercolor painting.

      Delete

Post a Comment

Popular posts from this blog

Warm & Cool Colors

Have you ever wondered about warm and cool colors and whats the difference. Warm color appear to move forward while cooler colors recede into the background. That's why when painting a landscape I prefer to use warm colors in the foreground then move to cooler colors and lighter values (meaning more water) in the background. If I was working on a floral I prefer to use warm or even a mix of color in the flower then use cooler colors in the shadows to give depth to my subject. 


Warm Colors Cadmium Yellow Pale, New Gamboge, Cadmium Yellow, Winsor Yellow Deep, Indian Yellow, Cadmium Yellow Deep, Cadmium Orange, Winsor Orange, Winsor Orange (Red Shade). Cadmium Scarlet, Scarlet Lake, Cadmium Red, Winsor Red, Rose Doré, Quinacridone Red, Opera Rose, Quinacridone Magenta, Permanent Magenta, Cobalt Violet, Permanent Mauve, Winsor Violet (Dioxazine), Cobalt Blue Deep, French Ultramarine, Ultramarine, (Green Shade), Winsor Blue (Red Shade), Cerulean Blue (Red Shade), Winsor Green (Yellow Sha…

Tips: Tools to Apply Masking Fluid

Most often people will use an old brush, incredible nib or Masquepen but depending on the flow, coverage and detail you want. There are a couple of other things you can try.
Lets say you want a nice continual flow of fluid to leave detail areas white. Consider an embossing tool (used for paper, foil, clay etc) or a calligraphy pen, both feel good in your hand and hold a nice amount of fluid. The flow of masking or drawing gum can also depend on the brand you use. Personally I like Pebeo drawing gum because it's thinner and applies easily.
Examples from students
 When signing paintings with a dark backgrounds Karen Richards like to use a Calligraphy pen to her apply masking. Once the composition is created she applies a light wash, lets it dry then signs her name. She will then continue with the painting then when done remove the masking to reveal her signature.
Karen Richards
Calligraphy pen
Pebeo Drawing gum
Revealed signature --- To get basically the same results Linda likes to use an e…

Glazing (layering) in watercolor

Glazing is a term for layering or stacking color, for instance think of different sheets of colored glass or tissue paper one stacked on top of the other. You are able to see through the transparent layers to the ones below, glazing in watercolor is the same idea but instead using thin washes of transparent color. For the cleanest color mixing and purest glazes use only the most transparent color. The reason is these colors allow light to pass through and reflect off of the papers surface leaving beautiful jewel-like effects.
Here are only a few of the transparent colors you may want to consider, New Gamboge, Indian Yellow, Winsor Red, Alizarin Crimson, Carmine, Permanent Rose, Quinacridone Magenta, Winsor Violet (Dioxazine), Indanthrene Blue, French Ultramarine, Cobalt Blue, Antwerp Blue, Prussian Blue, Viridian, Winsor Green (Yellow Shade), Perylene Green, Hooker’s Green, Permanent Sap Green among others.
More opaque the colors have a greater coverage and are useful to tone down color…